TY  - BOOK
AU  - Davis,Chad
ED  - Open Textbook Library
TI  - DC Circuits
T2  - Open textbook library
AV  - TA145 
PB  - Open Textbook Library
KW  - Engineering
KW  - Textbooks
KW  - Electrical Engineering
N1  - PrefaceModule 1 - The Basics of DC Circuits with Resistors -- Section 1.1 - Introduction and Basic Definitions -- Section 1.1.1 - Charge vs Current -- Section 1.1.2 - Resistance Calculations - (Resistance explained in more detail in section 1.1.3) -- Section 1.1.3 - Ohm's Law: Voltage, Current, Resistance, and Conductance -- Section 1.1.4 - Power and Energy -- Section 1.2 - Combining Resistors in Parallel or Series -- Section 1.3 - Kirchhoff's Voltage Law (KVL) and Voltage Divider Rule (VDR) -- Section 1.4 - Kirchhoff's Current Law (KCL) and Current Divider Rule (CDR) -- Module 1 - Equation List -- Module 2 - Advanced Topics for DC Circuits with Resistors -- Section 2.1 - Source Transformations: Thevenin and Norton Form -- Section 2.2 - Approximate Source Transformations: Adding a virtual resistor -- Section 2.2.1 - Voltage Source Approximate Transformation -- Section 2.2.2 - Current Source Approximate Transformation -- Section 2.3 - Mesh Matrix Analysis and traditional loop analysis methods -- Section 2.4 - Nodal Matrix Analysis and traditional Nodal Analysis -- Section 2.5 - Superposition: Solving a circuit by including only one source at a time -- Section 2.6 - Thevenin and Norton Equivalent Circuits -- Module 3 - DC Circuits with Resistors, Capacitors, and Inductors -- Section 3.1 - Background for Capacitors -- Section 3.2 - Background for Inductors -- Section 3.3 - Combining Inductors in Parallel and/or Series -- Section 3.4 - Combining Capacitors in Parallel and/or Series -- Section 3.5 - DC Transient Analysis with RC and RL Circuits -- Section 3.5.1 - Single Loop RL and RC Charging (Store) Circuits -- Section 3.5.2 - Single Loop RL and RC Discharging (Release) Circuits -- Section 3.6 - DC Steady State Analysis with RC, RL, and RLC Circuits -- Section 3.7 - Introduction to Passive Filters -- Module 3 - Equation List -- References and LinksAppendix - Dependent Sources and Laplace Transform Examples
N2  - This book covers Direct Current (DC) circuit theory and is broken up into three modules. Module 1 covers the basics for circuits that include DC sources (voltage or current) and resistors. Even though Module 1 is not very difficult, it forms the foundation for more complicated topics in modules 2 and 3 so it is important to have a firm grasp of all Module 1 topics before moving on. Module 2 covers more difficult problem solving techniques for circuits that include only DC sources and resistors. Module 3 introduces capacitors and inductors. These non-linear reactive components are analyzed in the transient and steady state regions in circuits with DC sources in Module 3. Also annexed is a two-page cheat sheet that ENGR 2431 students at University of Oklahoma can use for exams
UR  - https://open.umn.edu/opentextbooks/textbooks/534
ER  -